• Size: 4" x 1" x .375"
• Tough ABS Housing
• Weighs the same as a cell phone
• D.O.T. /EPA Compliant
• Lifetime Power Supply
• Installation: 3-Minutes
• No wiring
• No tools

HOW and WHY It Works

The overwhelming majority of the controlled traffic signals in the United States are regulated by electromagnets. Electromagnets that are used to sense iron, instead of lift it, are called inductive loops. These loops most often appear at controlled intersections as large black rectangles in the road. Inductive loops detect iron (ferrite [Fe]) not aluminum, rubber, plastic, weight, titanium, etc. Motorcycles, particularly the newer models, rarely have enough iron to cause the inductive loop to detect their presence at the intersection - ergo, the light does not change. Signal Sorcerer™ generates a very powerful field that substantially increases the inductance in these loops, therefore causing the traffic signal to detect the vehicle it's attached to, and initiate a cycle change. Inductive loop technology has been employed in this capacity since the early 1960's.

Installation

NO WIRING NEEDED • NO TOOLS NEEDED • AVERAGE INSTALLATION TIME: 3-Min.

The Signal Sorcerer® traffic light changer should be attached to the underside of the vehicle; parallel to the road; as close to the road's surface as possible; it should not have anything between it and the road. Your Signal Sorcerer® traffic light tripper should not be mounted on exhaust pipes or anywhere that it could interfere with the safe operation or service of your vehicle, such as on wheels, drive belts, or chains. The adhesive's specifications require that Signal Sorcerer® traffic light trippers be installed in temperatures above 50°F. Signal Sorcerer® traffic light changer does function below 50°F.

Installation Overview
Installation of your new Signal Sorcerer® traffic light changer is fast and easy. Signal Sorcerer® works best when closest to the road's surface, with no metal between it and the road. The Signal Sorcerer® traffic light changer may be mounted anywhere under your vehicle where it does not interfere with the safe operation of the vehicle. Do NOT attach a Signal Sorcerer® traffic light changer to a vehicle's wheels.

Step 1) Look underneath your vehicle to determine where to mount the Signal Sorcerer® traffic light changer. (NOTE: The Signal Sorcerer® traffic light tripper generates up to 50 pounds of magnetic pull, so we suggest that you do not try to slide it around to place it. Simply visually check your frame for a suitable location.)

Step 2) With the location for your Signal Sorcerer® traffic light changer determined, open the provided alcohol patch and thoroughly clean the area where the Signal Sorcerer® is to be mounted. After cleaning, allow the area to dry for about one minute.

Step 3) Peel off the back of the industrial acrylic foam mounting tape - and grip the Signal Sorcerer® edges very firmly for placement.

Step 4) Carefully move the Signal Sorcerer® to the mounting location and attach it. Press very firmly while slightly twisting your fingers to the sides - this ensures a good bond between the adhesive and the mounting surface. (The Signal Sorcerer® generates up to 50 pounds of magnetic pull, so it will pull itself to steel very quickly. Don't allow your fingers to be caught between the Signal Sorcerer® traffic light changer and the mounting location, or any other steel or injury may occur.)

Step 5) OPTIONAL: Wrap the provided UV/Chemical resistant nylon wire tie around the frame and Signal Sorcerer® and pull it tight. Trim off any excess wire tie for safety and appearance.